Included:
-1 x Analog Enail Controller (no coil)

Features:
-For use with 15.8mm, 20mm, and Standard Flat Coils w/ 5 Pin XLR Connectors
-Coil Wiring Pins 1 + 2:AC, 3:TC+, 4:TC-, 5:GRD
(Standard D-nail wiring)
-Approximately 6 ft total wire Length
-Compatible with 120v100w and 120v250w coils
-Heat from 0 to 1200º F in a 1-2 minutes
(To ensure maximum coil life, we do NOT recommend you max out the heater level. If you do, you risk the chance of damaging your coil - we are not responsible for any damage that you may do to your coil. Remember red hot coil = too hot)

TIP: It your coil does not heat up: When off, put your finger on the 'OFF' position on the dial and then turn clock-wise until your finger hits the 'ON' position or a bit higher until you hear your coil oscillate or raise in temperature. Turn your dial back down to the 'ON' position once it it starts to heat up and wait 1-2 minutes. This is the best average temperature setting to use if your using a TI nail + carb cap (may vary depending on coil -adjust accordingly to preference)

Warranty: 2-Year Warranty that covers any manufacturer defects or damage from normal everyday use. Any damage caused by misuse or accidental damage (ie. water damage, fire, leaving on max for extended periods) are not covered by our warranty. Products that are damaged and out of warranty may be repaired or fully replaced for a small fee.

**Free Shipping on all orders within the US via USPS First Class Mail or Priority Mail. All orders will be shipped out within 1-2 days after payment***

Disclaimer:
Please check your shipping address prior to checkout. Once orders are placed, we can not change the order or address that was provided.