Included:
-1 x Analog E-Nail Heater Controller
-1 x 16mm Kevlar Heater Coil
-1 x GR 2 Carb Cap + Flat Head Dabber
-1 x GR 2 14/18mm Female OR Male 16mm Nail
(Dependent on option below)

Details:
-Controller + 16mm, 20mm, OR Standard Flat Coils
-Coil Wiring Pins 1 + 2:AC, 3:TC+, 4:TC-, 5:GRD
(Standard D-nail wiring)
-Approximately 6 ft total wire Length (controller)
-5ft, Durable Kevlar Sheathed Coil
-Heat from 0 to 1000º+ F in a 1-2 minutes

CAUTION: Heaters that are connected to controllers are HOT while in use. Be sure to never leave units on while unattended and keep your items well-balanced. Be sure to NEVER max out your coil's heating temp. Coils can burn out if overheated for extended periods of time. If you do, you risk the chance of damaging your coil - we are not responsible for any damage that you may do to your coil.

TIP: It your coil does not heat up: When off, put your finger on the 'OFF' position on the dial and then turn clock-wise until your finger hits the 'ON' position or a bit higher until you hear your coil oscillate or raise in temperature. Turn your dial back down to the 'ON' position once it it starts to heat up and wait 1-2 minutes. This is the best average temperature setting to use if your using a TI nail + carb cap (may vary depending on coil -adjust accordingly to preference)

Warranty: 2-Year Warranty that covers any manufacturer defects or damage from normal everyday use. Any damage caused by misuse or accidental damage (ie. water damage, fire, leaving on max for extended periods) are not covered by our warranty. Products that are damaged and out of warranty may be repaired or fully replaced at a reasonable fee.

**Free Shipping on all orders within the US via USPS First Class Mail or Priority Mail. All orders will be shipped out within 1-2 days after payment***

Disclaimer:
Please check your shipping address prior to checkout. Once orders are placed, we can not change the order or address that was provided.